Filter
Top Products
23
7
8
1
3
2
9
10
Connect gas line and check
for leaks.
11
12
Final Installation (36”W. Double) (cont.)
Remove all knobs, push buttons, bezels, and lower
access panel, side trim, and control panel.
Remove control box, disconnecting the
three harness connectors.
Attach 8” pipe nipple through lower oven cabinet to
upper oven pipe tee. Attach female connector to pipe
nipple. Attach flex tubing to female connector.
Reconnect three harness connectors and
replace control box.
Replace side trim, control panel, lower
access panel, control panel knobs,
push buttons, and bezels.
22
1
2
2
1
3
3
2
1
3
4
1
2
5
6
Final Installation (36”W. Double)
Install upper oven as described on page 21, “Final
Installation” (36”W. single).
Place bottom oven on a protected area near the
cabinet. Remove 2” hole knockout from oven top.
Remove access panel from oven side and
pipe plug from pipe tee.
Attach male connector to pipe tee. Feed flex tubing
through 2” hole and attach to the male connector.
Replace access panel.
Push lower oven straight into cabinet.
Note: Purchase necessary gas kit – IKD-VGSO.