Filter
Top Products
CONTROL PANEL
10
On/O Switch (l)/(
O
): The switch is located on the front left side of the machine below the control
panel and below the On/O light. The On/O switch controls the power to the machine. While plugged in,
switch to On to ready the machine for blending. Shut o the power switch at night or whenever the
machine will be left unattended.
On/O Light: The light is located on the front left side of the machine below the control panel and
above the On/O switch. (See illustration above.) When lit, the machine is plugged in and the On/O
switch is powered On. The power light will flash when a pre-programmed setting is used to indicate that
the program is near completion. Push down the Start/Stop switch to activate a program or initiate
continuous Variable speed operation.
Start/Stop Switch
l
/
: Push down the Start/Stop switch to activate a programmed setting or the
Variable option. Push again to stop.
Variable Speed/Programming Dial: The center Variable dial serves two functions. When rotated left of center,
the dial is used to select one of three programs that are activated by pushing down the Start/Stop switch.
(Programs will automatically stop after a preset time.) When rotated right of center, the dial is used to select the
Variable speed of the blade. The machine is activated and stopped by pushing down the Start/Stop switch.
Pulse Switch : The pulse switch can be used to quickly refresh product in the container or to temporarily
activate the machine. In Variable settings (right of center), the pulse switch will activate at the speed setting of
the dial for the duration that the switch is held down. When the Variable dial is set on a program (settings left of
center), the pulse switch will activate at 50% of High speed for the duration the switch is held down.
IMPORTANT NOTES
Start/Stop Switch: If necessary, you may stop a program mid-cycle with the Start/Stop switch, not the
On/O switch. If the On/O switch is used by mistake, wait 30 seconds for power to recycle and the
timer to reset before resuming operation.