Filter
Top Products
7
Cover with Removable Hinge Design
Cover Door:
1. The Cover Door can be removed by opening it until the door is horizontal. Then,
gently spread the sides of the door over the round hinges and remove.
2. To reinstall the Cover Door, gently spread the sides of the door and place the door
hinge cutouts over the round hinges. (Figure C)
Back Cover:
1. To remove the Back Cover from the Blending Station:
a. First remove the Cover Door from the unit, as described above.
b. Remove the two (2) Back Cover mounting screws located on the rear of the
machine. (Figure D)
c. From the rear of the machine, firmly push the bottom of the cover forward
(towards the control panel), keeping the bottom edge of the cover against the
motor base.
DO NOT tilt or strike the cover during removal.
d. Slide forward until the side latches on the front of the cover are released from the
motor base.
DO NOT strike the cover to “pop” the side latches from their
tracks. Doing so will cause damage. The cover must only be removed by
sliding it forward (toward the Control Panel).
2. To replace the Back Cover on to the Blending Station:
a. Place the Back Cover on the motor base approximately one (1) inch forward of its
normal position.
b. Slide the cover towards the back of the machine (away from the Control Panel).
Make sure the side latches slide into their tracks.
c. Push until back of cover is seated against the Motor Base.
Make sure the Back Cover is fully seated in the back and the side latches
are in their grooves before inserting and tightening the mounting screws.
d. Replace and firmly tighten the two (2) Back Cover mounting screws. (Figure D)
DO NOT overtighten. DO NOT use the mounting screws to pull the Back
Cover into position. Doing so will cause damage.
Figure C
Figure D
Back Cover
Hinge
Mounting
Screws
Back Cover
Cover Door