Vulcan-Hart 1ER50DF Fryer User Manual


 
7
Australia, use only the caster supplied by the manufacturer for the fryer
device. The fryer must be installed using a hose assembly restraining device to
limit the movement of the appliance in accordance with AS1869.
The fryer must be installed with a connector (not supplied by Vulcan)
complying with the above codes.
The fryer must be installed with restraining means to guard against
transmission of strain to the connector. See illustration.
The fryer must be installed with the casters provided.
If the restraint is ever to be disconnected, turn off electric supply to the fryer.
If the fryer is installed on casters without a supply cord it must be hard wired using
flexible conduit when making connection to the power supply.
ELECTRICAL CONNECTION
Electrical and Grounding connections must comply with the National Electrical Code
and/or other local codes.
Disconnect the electrical power supply to the machine and follow lockout / tag out
procedures.
Appliances equipped with a 120V flexible electric supply cord are provided with a three-
prong grounding plug. It is imperative that this plug be connected into a properly
grounded three-prong receptacle. If the receptacle is not the proper grounding type,
contact an electrician. Do not remove the grounding prong from this plug.
For 480 volt fryers a separate cord and NEMA 15-5P plug is required (not supplied with
the fryer). Plug in the wire connection into an approved outlet.