Filter
Top Products
C24EO SERIES STEAMERS - REMOVAL AND REPLACEMENT OF PARTS
DOOR
Removal
1. Close door.
2. Remove left SIDE PANEL.
3. Remove nuts from upper hinge located inside
front panel.
4. Open door slightly, and while holding door, pull
upper hinge away from front panel.
5. Pull upper hinge out of upper door hinge
bushing.
6. Lift door assembly up and off lower door hinge.
7. Reinstall parts removed in reverse order of
removal.
8. Check door for fit and proper sealing of gasket.
Gasket
1. Open door.
2. Remove the shoulder screws and pan pusher
bracket from gasket plate.
3. Remove gasket plate.
4. Remove gasket from inner door panel.
5. Remove RTV from bottom part of inner door
panel. Apply new RTV 109 to bottom of door
where shown when assembling gasket to door.
6. Place a small amount of RTV109 into the inner
door panel gasket screw holes before assembly.
7. Position the new gasket on gasket plate and
reverse procedure to install.
Handle Removal
1. Open door.
2. Remove screws from top and bottom of door
assembly.
3. Pull outer door housing away from inner door
panel starting at the hinge side of door to
separate the door halves.
NOTE: The smaller radius of the step spacers fit into
the slots of the outer door housing and is used to
provide clearance for handle operation.
4. Remove lock nuts and stepped spacers from
threaded studs of door handle.
F25386 (June 2010) Page 10 of 24