Filter
Top Products
HALF-SIZE CONVECTION OVENS - REMOVAL AND REPLACEMENT OF PARTS
10
HEATING ELEMENTS
(ELECTRIC OVENS)
WARNING:
DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
1. Remove racks and the right rack support.
2. Remove baffle panel by lifting up and out.
3. Remove the right side panel as outlined under
“COVERS AND PANELS”.
4. Disconnect the lead wires to the heating
elements.
5. Remove the screws from the clamps that
secure the heating element assembly.
6. Pull the top of the heating element assembly
into the oven cavity until the ends of the
elements are inside the oven cavity. Lift up and
remove the lower clamp from between the side
wall and the bottom of the oven cavity.
7. Remove the clamps from the heating element
assembly and replace the element(s).
8. Reverse procedure to install.
TEMPERATURE PROBE
Procedure
WARNING
: UNPLUG UNIT BEFORE SERVICING.
1. Remove the control panel as outlined under
"COVERS AND PANELS".
2. Disconnect the probe leads at the temperature
control.
3. Remove probe from the probe guard and push
it thru the oven wall into the control panel area.
NOTE:
When installing, only the metal surface of
the probe should be inserted into the probe guard.
NOTE:
The probe may have to be inserted at an
angle. The hole in the inside oven cavity wall may
not line up straight with the oven cavity outer shell.
4. Reverse the procedure to install the new probe.
5. Adjust the temperature control as outlined
under "TEMPERATURE CONTROL
CALIBRATION" in "SERVICE PROCEDURES
AND ADJUSTMENTS".