Filter
Top Products
— 6 —
RANGES MOUNTED ON CASTERS
Ranges mounted on casters must use a exible connector
(not supplied by manufacturer) that complies with the
Standard for Connectors for Movable Gas Appliances,
ANSI Z21.69 • CSA 6.16 and a quick-disconnect device
that complies with the Standard for Quick-Disconnect
Devices for Use With Gas Fuel, ANSI-Z21.41 • CSA 6.9. In
addition, adequate means must be provided to limit
movement of the appliance without depending on the
connector and the quick-disconnect device or its associated
piping to limit appliance movement. Attach the restraining
device at the rear of the range as shown in Fig. 1.
If disconnection of the restraint is necessary, turn o the gas
supply before disconnection. Reconnect this restraint prior to
turning the gas supply on and returning the range to its
installation position.
Separate instructions for installing casters to the range are included with the casters.
Note: If the range is installed on casters and is moved for any reason, it is recommended that the range
be releveled front to back and side to side.
LEVELING
Curb Installation
Ranges must overhang curb 3" (76 mm) in front. To level each range, remove oven bottom. Adjust
four corner leveling bolts as required to level the appliance on all sides.
Convection Oven
Remove lower front kick plate. Remove two screws holding electric gas valve and move valve o to
the side. Pull oven burner out of compartment through opening. Adjust four corner bolts to level range.
Replace burner valve and kick plate.
Floor Installation on Legs
The 6" (152 mm) adjustable legs must be tightened securely. Level each range by turning the foot
portion of the adjustable legs.
Lining up Range Battery
In batteries of ranges, it is recommended that the center range be installed and leveled rst. Level each
range, one at a time, to line up high shelf and roll front with adjacent range. Bolt the high shelves and
roll fronts together.
PL-51219
CONNECT GAS LINE
STRAIN
RELIEF HERE
Fig. 1