Vulcan-Hart ML-52497 Oven User Manual


 
5
OPERATION
WARNING: THE OVEN AND ITS PARTS ARE HOT. BE VERY CAREFUL WHEN OPERATING AND
CLEANING THE OVEN.
CONTROLS (Fig. 1)
MAIN POWER SWITCH Turns power on or off.
PILOT LIGHT Main power is on when light is on.
TOP HEAT - IN Settings [ 0 - 10 ] adjust the first two heaters above the conveyor.
TOP HEAT - OUT Settings [ 0 - 10 ] adjust the final heater above the conveyor.
BOTTOM HEAT Settings [ 0 - 10 ] adjust the four heaters below the conveyor.
BELT SPEED Settings [ 0 - 10 ] adjust the conveyor speed.
BEFORE FIRST USE
WARNING: DISCONNECT ELECTRICAL POWER SUPPLY BEFORE CLEANING.
Clean all stainless steel parts with a soft cloth moistened in mild detergent and warm water to remove
any shipping dust and the protective oil film. Refer to CLEANING in this manual.
WARM-UP
Turn main power ON. Adjust dial settings for: Top Heat - In, Bottom Heat, Top Heat - Out, and Belt
Speed to medium position 5. Allow about 7 minutes for warm-up.
OPERATOR TIPS
Depending on settings for Top Heat - In, Top Heat - Out, and Bottom Heat, product can be baked on
top and/or bottom. Product is placed on the chain conveyor at the front and moves through the heated
oven chamber to the exit tray at the rear.
Fig. 1
PL-40949-1
Main Power Switch
Pilot Light
Top Heat-In
Top Heat-Out
Bottom Heat
Belt Speed