Vulcan-Hart VG60 Range User Manual


 
— 16 —
FLUE CONNECTIONS
DO NOT obstruct the flow of flue gases from the flue located on the rear of the range. It is recommended that
the flue gases be ventilated to the outside of the building through a ventilation system installed by qualified
personnel.
From the termination of the flue to the filters of the hood venting system, a minimum clearance of 18" (457 mm)
must be maintained.
Information on the construction and installation of ventilating hoods may be obtained from the standard for the
"Removal of Vapors from Commercial Cooking Equipment”, NFPA No. 96 (latest edition), available from The
National Fire Protection Association, Batterymarch Park, Quincy, MA 02269.
ELECTRICAL CONNECTIONS (CONVECTION OVEN MODELS [90 SERIES] ONLY)
WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE APPLICABLE
PORTIONS OF THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL ELECTRICAL CODES.
WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AND FOLLOW
LOCKOUT / TAGOUT PROCEDURES.
WARNING: APPLIANCES EQUIPPED WITH A FLEXIBLE ELECTRIC SUPPLY CORD ARE PROVIDED WITH
A THREE-PRONG GROUNDING PLUG. IT IS IMPERATIVE THAT THIS PLUG BE CONNECTED INTO A
PROPERLY GROUNDED THREE-PRONG RECEPTACLE. IF THE RECEPTACLE IS NOT THE PROPER
GROUNDING TYPE, CONTACT AN ELECTRICIAN. DO NOT REMOVE THE GROUNDING PRONG FROM
THIS PLUG.
The range is designed for 120 volt power supply or an optional 240 volt single-phase 15 Amp power supply.
All 120 volt ranges are supplied with a flexible electric supply cord and plug and must be plugged into the proper
receptacle before turning on gas. If the appliance is not equipped with a grounding plug and electric supply is
needed, ground the appliance by using the ground lug provided. All 240 volt electric systems are manufactured
for hard wire installation connections. (Refer to the wiring diagram inserted into this manual.) An electrical
diagram is attached to the back near the motor mounting area.
Do not connect the range to electrical supply until after gas connections have been made.