Filter
Top Products
— 17 —
OPERATION
WARNING: THE RANGE AND ITS PARTS ARE HOT. BE VERY CAREFUL WHEN OPERATING, CLEANING
OR SERVICING THE RANGE.
CONTROLS
THERMOSTAT DIAL - STANDARD OVEN — Allows operator to regulate oven temperature from low to
500°F (260°C).
THERMOSTAT DIAL - CONVECTION OVEN — Snap-acting type control which allows operator to regulate
oven temperature from 150°F to 500°F (65.5°C to 260°C).
OPEN TOP BURNER KNOB -
STANDARD AND CONVECTION OVENS — Regulates gas flow to top burners. To increase heat, turn
knob counterclockwise; to decrease, turn knob clockwise.
POWER SWITCH - CONVECTION OVEN — ON-OFF switch controls power supply to convection oven
control.
HEATING LIGHT - CONVECTION OVEN — When lit, indicates that the oven thermostat is calling for
heat to the oven.
GRIDDLE BURNER KNOB -
STANDARD AND CONVECTION OVENS — Regulates gas flow to the griddle or hot top burner. To
increase heat, turn knob counterclockwise; to decrease,
turn knob clockwise.
BEFORE FIRST USE
Griddle Seasoning
CAUTION: This griddle plate is steel, but the surface is relatively soft and can be scored or dented by the
careless use of a spatula or scraper. Be careful not to dent, scratch, or gouge the plate surface. Do not
try to knock off loose food that may be on the spatula by tapping the corner edge of the spatula on the
griddle surface.
A new griddle surface must be seasoned to do a good cooking job. The metal surface of the griddle is porous.
Food tends to get trapped in these pores and stick; therefore, it is important to “season” or “fill up” these pores
with cooking oil before cooking. Seasoning gives the surface a slick, hard finish from which the food will release
easily.
To season, heat griddle top section at a low burner setting. Pour one ounce of cooking oil per square foot of
surface over the griddle top section. With an insulated cloth, spread the oil over the entire griddle surface to
create a thin film. Wipe off any excess oil with an insulated cloth.
Repeat this procedure 2 to 3 times until the griddle has a slick surface.
LIGHTING AND SHUTTING DOWN PILOTS
All adjustment procedures associated with pilot lighting must be performed by an authorized Vulcan-Hart
installation or service person.