Filter
Top Products
— 13 —
PL-41127-1
CRUMB TRAYS
Air Distribution Panels
The oven is equipped with a top and a bottom air distribution panel. These panels regulate the quantity
of air on the top and bottom of the product that is being cooked. They have been adjusted at the factory
for proper baking performance. Some products may need additional panel adjustments. This should
be done by a Vulcan-Hart authorized servicer.
CLEANING
WARNING: DISCONNECT ELECTRICAL POWER SUPPLY BEFORE CLEANING.
Daily
Clean the outside of the oven daily by wiping with a clean damp cloth.
Avoid using abrasive powders or pads; these cleaners may damage the finish.
Remove the crumb trays on each side of the oven (Fig. 7) and clean in a sink as you would any normal
utensil. Also remove the center crumb tray (Fig. 7) and clean it. To remove the center crumb tray:
1. Remove the front panel by grasping each side of the door handle and lifting up.
2. Swing the bottom of the front panel out. Lower panel and pull away.
3. Before removing the crumb tray, loosen the conveyor belt (see Conveyor Belt Removal in this
manual) and brush away the crumbs under the belt.
4. After cleaning the center crumb tray, replace the tray and replace the front panel by reversing the
procedure.
Replace right-hand and left-hand crumb trays.
Fig. 7