Filter
Top Products
VCH & VRT SERIES OVENS F-41162 (03-14)
10
PRE-PROGRAMMED CYCLES
The Oven can be programmed for 9
cooking/holding cycles. (P-1 thru P-9)
To program each cycle, P-1 through P-
9, use the following instructions.
PROGRAMMING:
From the “Idle State” while the Time is
blinking:
1. Press and Hold the ADJ/SET
Button for 3 seconds. The time
will no longer blink.
The Cabinet Temp. will display
“P-0” and is blinking. Turn
Adj/Set knob to display P-1, go to
step 3.
2. If P-2 through 9 is the desired
cycle, Rotate the ADJ/SET
Knob to the desired pre-
programmed cycle.
3. Press and Hold the ADJ/SET
Knob for 3 seconds.
Time will start blinking.
4. Rotate the ADJ/SET Knob to
desired time.
5. Press the ADJ/SET Knob to
accept the time.
Cook Temp. will start blinking.
6. Rotate the ADJ/SET Knob to
desired cooking temperature.
7. Press the ADJ/SET Knob to
accept Cook Temp.
Hold Tem. will start blinking.
8. Rotate the ADJ/SET Knob to
desired holding temperature.
9. Press the ADJ/SET Knob to
accept Hold Temp.
10. Push Start Button
OPERATING:
1. Switch ON/OFF Switch to ON.
During the “Idle State/Time is blinking”:
2. Press and Hold the ADJ/SET
Knob for 3 seconds. The time
will no longer blink.
The Cabinet Temp. will display
“P-1” and is blinking.
3. Rotate ADJ/SET Knob to
desired pre-programmed cycle:
P-1 through 9.
4. Press Start Button.
You can push the ADJ/SET Knob any
time to abort the cycle and return to idle.