Filter
Top Products
3
PRECAUTIONS FOR SERVICING THIS EQUIPMENT
CAUTION: Never submerge electrical equipment in water.
Avoid contaminating electrical components with water when cleaning cooking surfaces
or cabinet.
Disconnect electrical power to equipment prior to performing cleaning or other service.
In order to avoid electrical shock, injury and/or equipment damage, use appropriate
precautions whenever electrical power must be restored for adjusting, calibrating or
taking voltage measurements.
Ensure that input power matches the nameplate data for voltage and phase.
Input power circuit must meet or exceed the nameplate power requirements.
Equipment is equipped with the proper electrical plug for the specific power
requirements of the unit. DO NOT alter the power cord or plug. Never cut off a ground
prong, or twist a prong, to allow the plug to fit an existing receptacle.
IMPORTANT: Never use a wire brush or metal scraper on aluminum components. Use a soft
bristle, fiber brush to clean grids.
Data sheets and text in this manual are representative of current production models as of
November, 2000. Specifications, Model Numbers, Product Numbers and data are subject to
change at any time without notice.
Whenever servicing is required to correct electrical or temperature complaints, always refer service
to a Wells Factory Authorized Service Agency.
Refer to Wells Form #37000 for a complete listing of factory authorized service agency locations.
CAUTION: Test electrical receptacle for proper polarity. For the safety of personnel,
it is important that electrical ground and electrical neutral are maintained as designed
by the factory.
CAUTION: DO NOT plug in or energize this appliance until Installation
Instructions are read and followed. Injury to the operator and damage to the Waffle
Baker may occur if these instructions are not followed.
CAUTION: This Wells Waffle Baker is equipped with a three-
prong electrical plug. The three-prong plug is part of a system
that will protect you in the event of an electrical wiring failure.
Be sure the three-prong plug is plugged into a matching and
properly grounded three-prong receptacle. DO NOT cut or
break off the ground prong of this plug.
OPERATING AN APPLIANCE WITHOUT PROPER GROUNDING
CAN RESULT IN SERIOUS PERSONAL INJURY
GROUND
PRONG