Filter
Top Products
6
A. CABINET ASSEMBLY
1. Insert the trademark plate from the front. From the rear of the cabinet, slide retainers over the
trademark plate pins. Using a deep socket, tap the retainers down until they are flush with the
cabinet surface.
2. Attach wires 1, 2, 3 & 4 to the switch. Thread one nut onto the switch shaft approximately 1/2”, then
slide the switch seal over the switch shaft. Insert the switch from the rear of the cabinet. Slide the
guard, then the on/off plate over the switch shaft. Thread on and tighten the second nut.
3. Work the seal over the body of the indicator light, then press the indicator into the cabinet until it
pops securely into place.
4. Install the support bracket.
5. Screw four rubber feet into the bottom panel, then install the bottom panel onto the cabinet.
CABINET
SUPPORT BRACKET
SEAL
INDICATOR
SWITCH
GUARD
ON/OFF PLATE
SEAL
TRADEMARK PLATE
RETAINER
RUBBER FOOT
BOTTOM
PANEL
SERVICING INSTRUCTIONS