Filter
Top Products
After the check, switch on the appliance.
The program continues from the point of in-
terruption. If the malfunction occurs again,
contact your Customer Care Centre.
If the display shows an alarm code, not de-
scribed in the chart, contact your Customer
Care Centre.
When you contact the Customer Care Cen-
tre you will need to give some details of the
appliance that can be found on the rating
plate (e.g. model number, serial number,
product number). We recommend that you
record these details.
THE WASHING RESULTS AND DRYING RESULTS ARE NOT SATISFACTORY
Problem Possible cause Possible solution
The dishes are not clean. The selected washing program
was not suitable for the type of
load and soil.
Make sure that the washing
program is suitable for the type
of load and soil.
The baskets were not loaded
correctly, water did not touch
all surfaces.
Load the baskets correctly.
The spray arms could not turn
freely because of incorrect ar-
rangement of the load.
Make sure that an incorrect ar-
rangement of the load does not
cause a blockage of the spray
arms.
The filters are dirty or not as-
sembled and installed correctly.
Make sure that the filters are
clean and correctly assembled
and installed.
The quantity of detergent was
not sufficient or missing.
Make sure that the quantity of
detergent is sufficient.
There are streaks, milky stains,
or a bluish layer on glasses and
dishes.
Rinse aid dosage is too high. Decrease the rinse aid dosage.
Dry water drop stains on
glasses and dishes.
Rinse aid dosage is too low. Increase the rinse aid dosage.
The detergent can be the
cause.
Use a different brand of deter-
gent.
The dishes are wet and dull. The rinse aid dispenser is emp-
ty.
Fill the rinse aid dispenser with
rinse aid.
The dishes are wet. You have set a washing pro-
gram without drying phase or
with a decreased drying phase.
Leave the door ajar for some
minutes before you remove the
dishes.
16 westinghouse