Filter
Top Products
II
Before you begin
Read these instructions completely and carefully.
If followed, they will simplify the installation job.
If your range does not have a microwave upper
oven, disregard the following microwave infor-
mation.
IMPORTANT:
Observe all governing codes and ordinances.
Failure to follow these instructions could lead
to fire or electrical shock hazard.
A. Space requirements
/
\
==lrll_i-i==
--
/’
-
I]
1 -a
L
A
B
III
L
CAUTION:
d
!
t-F-
I
go0
P
7”
MAX.
/ t
WALL
RECEPTACLE
I
\
PRECAUTIONS TO AVOID
POSSIBLE EXPOSURE TO
EXCESSIVE MICROWAVE ENERGY
Do not attempt to operate this oven with the door open
since open-door operation can result in harmful exposure to
microwave energy. It is important not to defeat or tamper
with the safety interlocks.
Do
not place any object between the oven front face and
the door or allow soil or cleaner residue to accumulate on
sealing surfaces.
Do not operate the oven if it is damaged. It is particularly
important that the oven door close properly and that
there is no damage to the:
1. Door (bent)
2. Hinges and latches (broken or loosened)
3. Door seals and sealing surfaces.
The oven should not be adjusted or repaired by anyone
except properly qualified service personnel.
The oven should be checked for microwave leakage by
qualified service personnel after a repair is made.
Do not operate the oven if the door glass is broken.
A=
Height for range with eye-level oven plus vent hood:
7l-7/8” min.
B=
Height for range with eye-level oven alone: 66-l/8” min.
C= Width between counters: 30-318” to 30-l/2”.
D= Height of countertop: 35.5/8” to 36.13/16”.
E=
Depth: 22-112”.
F=
Pigtail receptacle location: 8” to 22” from either cabinet,
7” max. from floor.
To prevent discoloration of base cabinet, front of oven frame
must extend at least l/2” beyond front surface of cabinets.
Do not seal range to cabinets.
The copper power cord (pigtail) must run downward, left or right
to the wall receptacle to avoid pinching the cord between rear
portion of the range and wall.
Top of eye-level oven may be installed against bottom of over-
head cabinet. However, for easy installation and removal, allow
1” clearance between oven top and cabinet. or 1” clearance
between hood top and cabinet. When hood is attached to cab-
inet, allow 1” clearance between hood bottom and oven top.
The back of a free-standing range may be installed against a
vertical wall. Sides may be installed against base cabinets or
against vertical walls extending above upper edge of the cook
top.
B.Check microwave for damage
Remove all packing material from the oven cavity. When
unpacking the unit, check for damage such as misaligned
door, damaged gaskets around the door, or dents inside the
oven or on the exterior. If there is any damage, please do
not operate the unit until it has been checked by an author-
ized Whirlpool trained service technician.
Reaching over heated surface elements causes risk _.
I-If
being burned. To eliminate hazard, cabinets should NOT
be installed above range.
If cabinets are already provided, reduce hazard by instal-
ling a range hood. Hood should project horizontally beyond
bottom of cabinets by a minimum of 5 inches.