Filter
Top Products
Before you start...
Your safety and the safety of others
is very important.
We have provided many important safety
messages in this manual and on your
appliance. Always read and obey all safety
messages.
0
!
This is the safety alert symbol. This
symbol alerts you to hazards that can
kill or hurt you and others. All safety
messages will be preceded by the safety alert
symbol and the word “DANGER” or
“WARNING”. These words
mean:
Proper installation is your responsibility. Make
sure you have everything necessary for correct
installation. It is the responsibility of the installer to
comply with the installation clearances specified
on the model/serial rating plate. The model/serial
rating plate can be found on the bottom of the
cooktop.
Check location where cooktop will be installed.
The location should be away from strong draft
areas, such as windows, doors and strong heating
vents or fans. The cooktop should be located for
convenient use in the kitchen.
When installing a cooktop under existing cabinets
and the installation does not meet the minimum
cabinet clearances, install a range hood above the
cooktop to avoid burn hazards.
ALL OPENINGS IN THE WALL OR FLOOR
WHERE THE COOKTOP IS TO BE INSTALLED
MUST BE SEALED.
Do Not obstruct the flow of combustion and
ventilation air.
Grounded electrical outlet is required. See
“Electrical requirements.”
Proper gas supply connection must be
available. See “Gas supply requirements.”
Countertop opening dimensions that are shown
must
be used. Given dimensions provide required
0” (0 cm) clearance.
Important: Observe all governing codes and
ordinances. Failure to meet codes and
ordinances could lead to fire or electric shock.
You will be killed or seriously injured if you
don’t follow instructions.
Cabinet dimensions
30” (76.2 cm) cooktop - 30” (76.2 cm)
min. cabinet width above cooktop
36” (91.4 cm) cooktop - 36” (91.4 cm) d
min. cabinet width above cooktop
13” (33.0 cm)
max. -
upper
You can be killed or seriously injured if you
don’t follow instructions.
All safety messages will identify the hazard, tell
you how to reduce the chance of injury, and tell
you what can happen if the instructions are not
followed.
for minimum
WARNING: If the information in
this manual is not followed
exactly, a fire or explosion may
result causing property
damage, personal injury or
death.
- Do not store or use gasoline or
other flammable vapors and
liquids in the vicinity of this or
any other appliance.
- WHAT TO DO IF YOU SMELL
GAS
l
Do not try to light any
appliance.
l
Do not touch any electrical
switch.
l
Do not use any phone in your
building.
l
Immediately call your gas
supplier from a neighbor’s
phone. Follow the gas
supplier’s instructions.
l
If you cannot reach your
gas supplier, call the fire
department.
- Installation and service must
be performed by a qualified
installer, service agency or
the gas supplier.
36” (91.4 cm)
cooktop -
1” (2.5 cm)
min. space to
front edge of
countertop
Wall ‘gas line
15” (36.1 cm)
opening - 5”
max. from
2-112”
bottom of
(6.4 cm)
(12.7 cm) below
countertop and
countertop
burner box
height
*** Note: 30” (76.2 cm) min. when
bottom of wood or metal cabinet
is protected by not less than 114”
(.6 cm) flame retardant millboard
covered with not less than No. 26
MSG sheet steel, 0.015” (.04 cm)
stainless steel, 0.024” (.06 cm)
aluminum or 0.020” (.05 cm)
copper.
36” (91.4 cm) min. clearance
between the top of the cooking
platform and the bottom of an
unprotected wood or metal sheet.
power supply cord
between the cooktop
and cabinet.
16-3/Y
16-3/4”
(47.6 cm) min.
(47.6 cm) min
Cutout dimensions
I’B‘I
cutout:
A depth
26-l R”
(67.3 cm) min.
33”
(63.6 cm) min.
B width
It is the customer’s responsibility:
l To contact a qualified electrical installer.
l To assure that electrical installation is
adequate and in conformance with
National Electrical Code, ANSUNFPA
70 - latest edition* and all local codes
and ordinances.
Mobile home installation
The installation of this cooktop must conform
to the Manufactured Home Construction and
Safety Standards, Title 24 CFR, Part 3280
(formerly the Federal Standard for Mobile
Home Construction and Safety, Title 24, HUD
Part 280); or when such standard is not
applicable, the Standard for Manufactured
Home Installation 1982 (Manufactured Home
Sites, Communities and Setups), ANSI
A225.1/NFPA 501A - 1987, or latest edition,
or with local codes.
2-5ia~~
2-5W
(6.7 cm) min. (6.7 cm) min.
c fyp~~to
nearest rear
combustible
surface
above
cooktop.
DM
inimum
distance to
nearest side
combustible
surface
above
COOktOD.
---c- ----
.
., -
A
l .
l .
l .
.
‘\
\
\ \
L---D
&&
D
5-114”
(13.3 cm) min.
S-114”
(13.3 cm) min,
Minimum distance to
nearest side combustible
surface above cooktop.
Product dimensions
30” (76.2 cm) min. base cabinet
is
required. If cabinet has a drawer, a
3-l/2” (8.9 cm) depth clearance from
the countertop to the top of the drawer
(or other obstruction) in base cabinet is
required.
30” (76.2
cm)
cooktop
Copies of the standards listed may be obtained from:
l
National Fire Protection Association
Batterymarch Park
Quincy, Massachusetts 02269
l
* American Gas Association
1515 Wilson Boulevard
Arlington, Virginia 2,2209
36” (91.4 cm) min. base cabinet
is
required. If cabinet has a drawer, a
3-l/2” (8.9 cm) depth clearance from
the countertop to the top of the drawer
(or other obstruction) in base cabinet is
required.
GrilUgriddle cooktop must be used
with suitable vent hoods.
Panel A