Filter
Top Products
-
Alternate drain hose connection
methods:
Drain hose to waste tee.
Cut hose
Recommended drain hose
connection methods:
Drain hose to air gap to waste tee.
Air-gap kit
A
&Part No.
Floor Damage
Tilt dishwasher backwards on wheels
when moving across floor.
Failure to do so may cause damage
to floor covering.
Rubber connector 3
Waste tee <
minimum
clearance
to floor
If local plumbing codes permit,
dishwasher drain hose may be
connected directly to waste tee*. The
waste tee connection MUST be made
ahead of the trap and a minimum of 20”
above the floor.
8
w Latch dishwasher door. Push
dishwasher into place, sliding drain hose
through hole cut in cabinet opening.
Do not pinch power supply cord or kink
power supply cable between
dishwasher and cabinet. Check that
front leveling legs are firmly against the
floor. Align dishwasher door with
cabinet doors, so that spacing is the
same on both sides.
t
abbve trap.
Drain hose to air gap to disposer.
Drain hose to disposer.
‘5b connector.
9
w Connect drain hose to an air gap
clearance
to floor
connector
to fit.
or waste tee using one of the
recommended or alternate methods.
Cut hose connector to fit. if needed.
If local plumbing codes permit,
dishwasher drain hose may be
connected directly to disposer. Most
disposers have 7/8” connectors or special
connectors are available at plumbing
supply houses. Be sure to remove the
disposer plug before connecting the
drain hose.
*All parts are available through your
dealer or local hardware or plumbing
store.
clearance t
to floor U
I
Pk
Entry must be
I I
above trap.
Install air gap (Part No. 300096)’
according to kit instructions. If other
brands of air gaps are used, they should
be checked to make sure they allow for
the same water flow.
Connect the air gap to a waste tee* or
disposer using a rubber connector*.
Most disposers have 7/8” connectors or
special connectors are available at
plumbing supply houses. Be sure to
remove the disposer plug before
connecting the drain hose.
If connecting drain hose to an air gap or
waste tee, cut end of drain hose as
shown,
Secure drain hose with screw-type or
spring-type hose clamp (clamp type
varies with models.)
Do Not cut drain hose when connecting
to a 7/8” disposer connector. Knock out
plug from disposer inlet. Secure drain
hose with hose clamp provided.
DO NOT cut ribbed section to shorten
drain hose.
drain hose
Numbers
correspond
to steps.
Panel C
-