Filter
Top Products
/equally spaceda,
To change door
panel color
NOTE: The opposite side of the door
color panel is a different color.
Product Damage
Do Not solder within 6” of plastic
water inlet valves.
Failure to follow this instruction could
result in product damage.
water inlet valve
Personal Injury Hazard
Wear gloves and handle panels
carefully.
Cut metal edges may cause personal
injury or damage to other materials.
14
n
Open door approximatelv 3”
and check’for equal spacing between
inner door and tub sides. If necessary,
loosen screws that fasten dishwasher to
countertop and shift tub. Tighten screws.
1
H Push up at
each end of
retainer at
bottom of door
panel. Then pull
retainer toward you. Set retainer aside.
10
n
Connect water pipe or tubina
directly to water inlet valve. Do Not run
pipe or tubing across front of motor or
dishwasher legs. Turn on water supply
and check for leaks.
2
n
Slide panel(s)
down to clear
console. Use both
hands to bow top and
bottom edge of door
panel(s). Remove
panel(s) from door.
Do Not remove
spacer.
11
. Check electrical requirements.
operation. Door should
ciose easily
without slamming and open with its own
weight. If necessary, close door and
adjust both door springs by moving
spring ends to different holes in base.
Be sure you have correct electrical
supply and recommended grounding
method. See Panels A and B for proper
connection.
3
H With desired
color facing out,
insert one side of
door panel(s) into
one side of door
frame.
16
n
Take a few minutes to read the
top mounting brackets
attached to underside
of countertop.
.- -4
Use and Care Guide to fully understand
your new dishwasher.
17
n
Check that all parts have
been installed and no steps were
skipped. Check that you have all the
tools you started with.
c
. Bow door panel(s)
and insert other side of
door panel(s) into door
frame.
l3SSES control console
18
n
Turn on electric supply. Start
dishwasher and allow it to complete a
cycle. Check that dishwasher is working
properly and that there are no water
leaks.
Do Not
drop
screws
into tub.
ti
n
Push in on
door panel(s) near
the top and slide
panel(s) and
spacer up inside
bottom of control
console.
12
n
Open dishwasher door and
remove all shipping materials, Remove
bottom rack. Place a newspaper or
large sheet of paper over bottom of
dishwasher to protect the pump area
when securing dishwasher to
countertop.
lower door
frame
toe pbnel
panel
19
n
Replace the access panel
6
n
Lift up and hold panel(s) and
and toe panel. The toe panel must be
positioned to contact floor.
spacer l/4” above lower door frame.
Personal Injury/Product Damage
Hazard
l
The dishwasher must be secured to
the countertop to keep it from tilting
when door is open.
l
Do Not drop screws in dishwasher
tub. If screws should fall into pump,
pump and motor damage may
occur.
Failure to follow these instructions
may result in personal injury or
product damage.
20
n
If changing color of door and
access panel or installing custom
panels, follow the “To change door
panel color” and ‘To change access
panel color” instructions, Panel D and E.
Congratulations!
You
have
just finished insfalling
your new undercounter
dish washer. Keep lnsfallafion
Instructions available for easy
reference.
13
n
Secure dishwasher to
countertop with two, No. - 10 x l/2”
Phillips-head screws from parts bag. You
MUST secure dishwasher to keep it from
tilting when door is opened or closed.
Do Not drop screws in dishwasher tub.
Remove paper from bottom of
dishwasher.
/
n
Insert retainer over lower edge of
door frame while holding door panel(s)
and spacer up.
8
n
Snap retainer
down into place.
Push down
firmly along entire
length of retainer to
make sure retainer is secure.
Slide door panel(s) down.
Panel D