Filter
Top Products
b
Numbers
correspond
to steds.
In jury Hazard
Use two or more people to move and
safely install vent system.
Failure to follow this instruction can result
in back or other injury.
9
n
Insert downdraft vent into
countertop cutout. Two people are
recommended to support the weight of the
downdraft vent during lifting. Position
downdraft vent so it is centered in cutout
and parallel to edge of cutout. Check that
downdraft vent is level vertically Then
fasten lower support legs to cabinet floor
with screws. Snap end caps over top of
mounting brackets.
When attaching undercounter bracket to
underside of countertop:
Do Not drill into countertop surface.
Check that mounting screws are proper
length and will not go through countertop
surface when tightened in place.
10
Attach one undercounter
n
bracket on front upper right
corner of downdraft vent with slot over vent
mounting hole and flange against
countertop. Attach other bracket to left
side of downdraft vent. Carefully drill starter
holes through undercounter mounting
brackets into underside of countertop.
Insert appropriate length screws into holes
and tighten brackets to countertop.
11
’ Disconnect power
SUDP~Y.
Thread
the power supply cable through the
knockout opening in the wiring box.
Connect the white wires together with a
twist-on wire connector. Connect the black
wires together with a twist-on wire
connector. Attach the green (or green and
yellow) grounding wire to eyelet with green
grounding screw. Reattach the wiring box
cover.
6.
Top corners of filter frame
must press against
microswitch behind filter.
ON/OFF
,
, button
n
Turn power supplv on. Push the
button on the top of the do&draft vent.
Retractable section of downdraft vent will
rise and blower will start. Turn the control
knob on side of vent to check the
operation and speed of blower.
If blower does not operate:
l Check that filter frame is pressed in as far
as it will go.
l Check that circuit breaker is not tripped
or house fuse blown.
l Disconnect power source and check that
wire connections have been made
correctly.
13
n
Connect ductwork to blower
Position ductwork to avoid wall studs and
floor joists. Complete all ductwork. Use duct
tape to seal all joints. Ductwork must end
with a wall or roof cap.
14
n
Install cooktoo accordina to
manufacturer’s instructions. Check t6at rear
edge of cooktop overlaps edge of
retractable downdraft vent by 3/8”.
Keep Installation Instructions close
to downdraft vent for easy reference.
( Congratulations ! )
The instructions will make reinstalling
~~~:~~;~v~
Panel D
_-
,