Filter
Top Products
3. If connectinq to a four-wire electrical system (mobile
home):
A. Remove termrnal block cover.
B. Remove the ground strap from the termrnal block
and from the appliance frame. Retain the ground
screw.
C. Connect the grounding wire (green) of the copper-
power supply cord to the frame of the appliance with the
grounding screw, using the hole in the frame where the
grounding strap was removed.
See Figure5
D. Connect the neutral (white) wire of the copper
Power
supply
cord to the center silver-colored termina!
of the terminal block and connect the other wires to
the outer terminals. Ring type terminals must be used
on the copper power supply cord wires,
E.
Replace the terminal block cover.
ILVER-COLORED
BARE OR NO
GROUNDING
(WHITE OR CENTER)
STRAIN RELIEF
(40 AMPERES)
WIRING DEVICE
FOR COPPER
POWER SUPPLY
FIGURE 5
1 CORD.
STEP 4
LEVEL AND
POSITION RANGE
1. Move the range to its final operating position and
check the level of the range by using a small spirit level
on the oven rack.
See Figure
6. The range can be
leveled from side to side and front to rear by adjusting
the four leveling legs.
FIGURE 6
FIGURE 7
2. Make the electrical connection:
A.
Plug the flexible copper connector (pigtail) into an
approved, receptacle (where local codes permit the use
of a pigtail),
OR
B. Connect the flexible armored or non-metallic shielded
copper cable directly to a fused disconnect box.
3. Remove the tape holding the oven light switch
actuator.
See Figure 7.
NOTE: As shipped from the factory, the oven lrght
switch actuator is held depressed by tape. To prevent
switch damage, the swatch actuator should be taped
whenever the range is transported.
4