Filter
Top Products
most efficient use from your new
range, read your Whirlpool Use&Care
Congratulations!
finished installing your
new Whirlpool ranae. To aet the
Guide. Keep Installation Instructions
and Guide close to range for easy
reference. The instructions will
make reinstalling your Whirlpool
h
LX Gas
Conversion
(Electronic Ignition and Standing
Pilot Systems)
Converttng to L.P. gos
should be done by
a quaffled Installer.
Nahml
A
Only a qualified
installer should
n
Install or
adjust your gas range.
Pressure Regulator:
Use a wrench to
unscrew the COD from
the top by turning counter-
clockwii. Turn the cap over so the hole
end is up. Replace the cop and gasket
on the regutator. DO NOT REMOVE THE
PRESSURE REGULATOR.
Part No. 76724.CQ/4320880
01990 Whirlpool Corporation
Burners:
Turn the orifices
hood down until snug
against pin. DO NOT OVERTIGHTEN.
Adjust the air shutters for proper flame by
sliding the air shutter to close or open the
shutter as needed. See Panel C, Step 18
for electricul lgtition systems or Step 19P
for standing pllot systems.
Caoktop burners with standing pilots
require adjustment of pilot flame to l/4’
hlgh. The adjustment control is located
on the manifold plpe or at pilot ftame
base, depending on the model,
TKifl 01
2
CORPORAllON
C
’
Oven Burner: Remove oven
racks and lower panel from
oventottom. Turn the orifice hood
down until snug against pin. DO NOT
OVERTIGHTEN. The burner flame should
be l/2’ long when air shutter is correctly
adjusted The air shutter slides to close or
open the shutter OS needed. See Pane
C, Step 21 for electronic ignition systems,
or Step 23A for standing pilot systems.
Replace oven bottom ond rocks.
D
Oven thermostal: Remove
.
thermostat knob. pulling straight
off. Use a small screwdriver to rotate the
key to L.P. Replace thermostat knob.
E
After all the burners have been
converted to L.P. gas usage and
gas~ne is connected, check for leaks.
Use a brush and liquid detergent to test
all gas connections for leaks. Bubbles
around connections will indicate a
leak. If a leak appears, shut off gas
valve controls and wrench-tighten
connections. Then check connections
ogoln. NEVER TEST FOR GAS LEAKS WITH
A MATCH OR OTHER FLAME.
Prepared by Whirlpool Corporation. Benton Harbor. Michigan 49022
Printed in U.S.A