Filter
Top Products
26-3/4"
(67.9 cm)
depth with
handle
3
Parts supplied for
installation:
Product
dimensions
Contact a qualified
floor covering
installer to check that
the floor covering
can withstand at
least 200°F.
Use an insulated pad
or 1/4" plywood
under range if
installing range over
carpeting.
For minimum
clearance to top
of cooktop, see
NOTE.*
18" (45.7 cm)
min. clearance
upper side
cabinet to
countertop
This shaded area
recommended for
installation of gas
pipe.
This shaded area
recommended for
electrical outlet.
Proper gas supply
connection must be
available. See “Gas
supply requirements,“
Page 4.
Grounded electrical
outlet is required.
See “Electrical
requirements,“
Page 4.
Cutout dimensions/requirements
Check location where range will be installed. The
range should be located for convenient use in the
kitchen. Recessed installations must provide complete
enclosure of the sides and rear of range.
All openings in the wall or floor where range is to be
installed must be sealed.
IMPORTANT:
Some cabinet and building materials
are not designed to withstand the heat produced by
the oven for baking and self-cleaning. Check with your
builder or cabinet supplier to make sure that the
materials used will not discolor, delaminate or sustain
other damage.
(Bracket must be securely mounted to
sub-floor. Thickness of flooring may
require longer screws to anchor the
bracket to sub-floor.)
anti-tip bracket
2 screws (#10 x 1-1/2")
2 plastic anchors
Not shown:
• literature pack
• orifice spuds
The floor anti-tip
bracket must be
installed. To install
the anti-tip bracket
shipped with the
range, see Page 5
and the anti-tip
bracket template.
Anti-tip bracket:
29-7/8" (75.9 cm)
width
46-1/4" (117.5 cm)
overall height for
tall backguard
models
24-1/4"
(61.6 cm)
36"
(91.4 cm)
cooktop
height
13" (33 cm) max.
upper cabinet
depth
30-1/8" (76.5 cm)
opening width
30" (76.2 cm) min.
cabinet opening width
8"
(20.3 cm)
2"
(5.1 cm)
10"
(25.4 cm)
24"
(61.0 cm)
5"
(12.7 cm)
5"
(12.7 cm)
2" (5.1 cm) min.
countertop space to
side wall or other
combustible material
3"
(7.6 cm)
Do not seal the range to
the side cabinets.
If cabinet depth is greater
than 24" (61 cm), oven
frame must extend
beyond cabinet fronts by
1/2" (1.3 cm) min.
* NOTE: 24" (61 cm) min. when bottom of wood or
metal cabinet is protected by not less than 1/4"
(0.64 cm) flame retardant millboard covered with
not less than No. 28 MSG sheet steel, 0.015"
(0.4 mm) stainless steel, 0.024" (0.6 mm)
aluminum or 0.020" (0.5 mm) copper.
30" (76.2 cm) min. clearance between the top of
the cooking platform and the bottom of an
unprotected wood or metal cabinet.