Filter
Top Products
Operating Instructions
Continued
Cycle selector buttons
0 0 0
Option selector buttons
Cycle control knob
Starting your dishwasher
1. Push a Cycle Selector Button for the desired
cycle.
2. Push an Option Selector Button for each
desired option. (Use AIR DRY for RINSE &
HOLD Cycle.) The indicators above the buttons
will show which cycle and option(s) have been
selected.
3. Turn Cycle Control Knob clockwise to point to a
desired cycle. You will feel a definite stop at
each cycle mark. The dishwasher will automati-
cally start that cycle.
NOTE: HEAVY WASH and POTS & PANS
Cycles share the same spot on the dial. LOW
ENERGY WASH and CHINA CRYSTAL Cycles
also share a spot on the dial. The Cycle Selec-
tor Button determines which cycle operates.
To add a dish after starting
1. To be sure the added item is washed and
rinsed, make sure the Cycle Control Knob has
not passed LOW ENERGY WASH.
2. Lift up on the door latch to unlatch door and
stop the cycle. Don’t open the door until the
spray arms stop spinning.
3. Open the door and add the dish.
4. Close the door. Do not latch it. Wait 30 sec-
onds for air in the dishwasher to warm up. This
helps reduce the amount of moisture that can
come from the vent when restarting the cycle.
5. Press door firmly to latch it. The dishwasher will
automatically start where it stopped.
4