Whirlpool ECKMF-28 Ice Maker User Manual


 
NOTE. GREEN
WIRE MUST BE
STEP A10
AlO. Connect Ice Maker to wiring assembly. Place
the ice maker on the side of the freezer so:
1. Wiring lays between shield and Ice Maker.
2. Plug is flat against the shield.
3. Wiring is above the bracket on the back of
Ice Maker.
WARNING-DO NOT PINCH WIRES BETWEEN
BRACKET AND SIDE OF FREEZER.
ROTATE CLIPS
Al 1. Put screw (#489069) through bottom bracket
and into freezer wall, then turn the 2 top clips
down (Step A5). Tighten all 3 screws.
TIGHTEN SCREWS
A12. Place ice bucket under Ice Maker.
\
\
SCREW
Y‘w9069
BRACKET
STEPAll -STEPA
B. INSTALLING WATER LINE AND WIRING
ON BACKOF CABINET
Bl. Place clamp (#488878) over spout of water
tube fitting. Put tube insert (#841707) in one
end of tubing that has been soaking in hot
water. Put tube insert and end of tubing into
spout. Tighten clamp with screw (#488645).
CLAMP Y4a8816
(WITH SCREW Y4.38645)
(FEEDS UNDER
WIRING ASSEMBLY
B2. Slide 2 clamps (#488366) over tubing.
Remove the screw from cabinet and attach
upper clamp to cabinet with this screw. Use
screw (#488645) from kit to attach lower
clamp to cabinet. Hold wires away from screw
when tightening.
-48
CLAMPS