Filter
Top Products
Moving the meat
drawer and cover...
To remove the meat drawer:
PULL OUT TO STOP. LIFT THE
1.
Slide the meat drawer out to stop.
FRONT AND PULL AGAIN.
2. Lift the front.
3. Slide the drawer the rest of the way out.
4. Replace in reverse order.
To
remove the cover:
AVY.
1.
Tilt front of cover up, lift at back, and pull straight
out.
2. Replace in reverse order.
Changing the light bulbs...
3. Replace with a 40-watt appliance
bulb.
Removing the base grille...
1.
Open the doors.
2. Pull grille outwards as shown.
3. Do
not remove Tech sheet
fastened behind
grille.
METAL CLIPS
SUPPORT TABS
To replace the grille:
1.
Line up grille support tabs with metal clips.
2. Push firmly to snap into place.
3. Close the doors.
Ice cube trays...
If cubes are not used, they may shrink. The mov-
ing cold air starts a slow evaporation. The longer
cubes are stored, the smaller they get.
r EEz$both ends.
2. Slightly twist
Optional automatic ice maker...
If you have the automatic ice maker accessory,
or if you plan to add one later (Part No. ECKMF-831,
there are a few things you will want to know:
l
The ON/OFF lever is a wire signal arm.
Downfor making ice automatically.
Up...to shut off the ice maker.
DO NOT TURN ICE MAKER ON UNTIL IT IS CON-
NECTED TO THE WATER SUPPLY.
LOWER
SIGNAL
ARM TO
START IT
RAISE
SIGNAL
ARM TO
STOP ICE
l
The dial or lever on the side of the ice maker
changes the size of the cubes.
l
You will hear water running when ice maker is
l
Shake the bin occasionally to keep cubes sepa-
working: You’ll hear ice fall into the bin. Don’t let
rated, and to obtain increased storage capacity
these sounds bother you.
l
The ice maker will not operate until the freezer
l
It is normal for ice crescents to be attached by a
is cold enough to make ice. This can take
corner. They will break apart easily.
overnight.
continued on next page