Whirlpool EV130E Freezer User Manual


 
Install properly...
Remove sales labels...
I, Check the strength of the floor. It should hold the
weight of a fully loaded freezer
2. Pick a safe place, indoors, away from in-
flammables such as gasoline.
3 Allow 3 inches (7 5 cm] arr space on top of freezer
for proper ventrlation.
4. Allow at least an inch (2.5 cm) between the
freezer condenser, on the back of the unit, and
the wall
5 Allow % inch (1 25 cm) on each srde of the freezer
for ease of installation.
6. If the freezer is to be against a wall, you mrght
want to leave extra space on the hinge side so the
door can be opened wider.
Level freezer...
so the door will stay
open at any position.
Raise lower
Start ad)ustment with the door hinge side.
I, Slide the freezer into place.
2. Adjust front legs to level the freezer.
-To raise front, turn legs clockwise.
-To lower front, turn legs counterclockwise.
3. Check with level.
4. After freezer is fully loaded, recheck with level
Remove the Consumer Buy Guide label and any
lnslde
labels before using the freezer
To remove any remalnlng glue:
1. Rub briskly with thumb to make a ball, then
remove
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water] be-
fore removing glue as described in step 1
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE the Tech Sheet fas-
tened under the freezer at the front.
Clean it . . .
Clean your freezer befor
using it. See cleaning
tnstructions on page 6.
Plug it in...
j-prong grounding
type wall receptacle
Retaining Clip
Freezer 1
Power Plug
I
grounding-plug
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is required.
It is recommended that a separate circuit serving only
this appliance be provided.
Use a receptacle
which cannot be turned off with a switch or pull
chain. Do not use an extenslon cord.
Attach retaining clip over power cord plug from
literature package inside the freezer.