Filter
Top Products
Install properly...
I. Check the strength of the floor. It should hold the
weight of a fully loaded freezer.
2. Pick a safe place, indoors, away from in-
flammables such as gasoline.
3. Allow 3 Inches (7.5 cm) air space on top of freezer
for proper ventilation.
4. Allow at least an inch (2 5 cm] between the
freezer condenser, on the back of the unit, and
the wall.
5 Allow l/2 Inch (1.25 cm] on each side of the freezer
for ease of installation
6. If the freezer is to be in a corner, you might want to
leave extra space on the hinge side so the door
can be opened wider
Level freezer...
so the door will stay open at any position.
Levelling Leg
oyer
1. Keep the 4 bolts that hold refrigerator in shipping
crate. They are the levelliny legs.
2. Screw these bolts all the way into bolt holes at the
bottom corners of refrigerator Move refrigerator
into place.
3. Adjust each leg until the refrigerator won’t rock.
4. Adjust front legs to level the refrigerator
- To raise corners, turn legs in direction shown,
- To lower corners, turn legs in direction shown.
5. Check with level.
Remove sales labels...
Remove the Consumer Buy Guide label and any
lnslde
labels before using the freezer.
To remove any remalnlng glue:
1. Rub briskly with thumb to make a ball, then
remove
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) be-
fore removing glue as described in step 1.
DO NOT USE rubblng alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachlorlde, etc. These can damage the
surface flnlsh.
NOTE: DO NOT REMOVE the Tech Sheet fas-
tened under the freezer at the front.
Clean it . . .
Clean your freezer before
usrng it. See cleaning
instructrons on page 7.
Plug it in...
3-prong grounding
Retaining Clip
1
Power Plug
grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Use a
receptacle which cannot be turned off wlth a
switch or pull chain. Do not use an extenslon
cord.
Attach retaining clip over power cord plug
from literature package inside the freezer.
4