Filter
Top Products
Changing the light bulb...
light Shield
Removing the bottom trivet . . .
To remove:
1 Lift front of trivet out of supports
2
Pull out
To replace:
1 Position bock of trivet on the rear wall supports
2 Lower front into place
The key eject lock...
can help reduce the hazard of child
entrapment
Lift the Front,
Then Pull Out.
The signal light...
automatically warns of any unexpected
power failure.
--
Signal Light
/
WARNING: To avold possible shocks, first unplug
freezer or turn off electrlclty leadlng
to freezer at the maln power supply.
I. Remove the light shield from the side of the control
panel. Depress the back of the shield to release the
tabs, then pull away.
2. Replace bulb with a 40-watt appliance bulb.
3. Replace the light shield. Insert the shield tabs in the
slots, then press the shield to snap into place.
4. Plug in power cord or switch on electricity
If the signal light is not glowing, immediately cl
0 for power interruption,
l
for an unplugged power cord,
l
for a burned out signal light.
ieck:
To lock or unlock the freezer you must hold the
key in the lock while turning. The lock is spring
loaded so the key cannot be left in the lock.
If the key is lost, contact your WHIRLPOOL
dealer for a replacement. Always give the
com-
plete
model and serial number of your freezer
when requesting a replacement key.
To replace burned out slgnal light:
I. Unplug power cord from outlet.
2. Open the freezer door
3. Unplug burned out light and replace with one of
same wattage and size. Signal light can be
ordered from your WHIRLPOOL dealer,
Part No. 1103680
4. Close freezer door and plug power cord into outlet.
6