Filter
Top Products
Bottom basket.. .
Chanlging light bulb.. .
To remove:
l
Lift up, then pull
o
To replace:
0 Insert into rear sli
0 Lower into place.
l
Push basket into freezer.
Cleaning your freezer
This freezer should be cleaned when frost has
built up to about l/4 inch (6 mm) thickness. Com-
plete defrosting and cleaning should be done at
least once a year. In high humidity areas, a freezer
may need more frequent defrosting.
To defrost and clean:
I. Turn Cold Control to OFF.
2. Unplug power cord.
3. Take out all food and removable parts.
Note: Wrap frozen foods and packages in sev-
eral layers of newspaper and cover with a blan-
ket. Food will stay frozen several hours.
4. Place pans of hot water inside freezer to speed
melting of frost. Keep door open. Ice can be
removed in large pieces as it melts.
Direct air from electric fan into freezerto speed
defrosting.
5. Remove base grille, see page 7.
6. Unclip hose and allow water to drain through
hose into a flat pan.
Removing the base grille...
2. Pull grille outwards a\s shown.
3.
Do not remove Tech sheet
fastened behlnd grrlle
1.
2.
3.
4.
5.
7.
Unpl .Jg power cord.
Rem:)ve light shield by pulling away from the
side wall.
Replxe bulb with 40 watt appliance bulb.
To replace shield, insert tabs into slots in wall
and press.
Plug gower cord into outlet.
Clecln freezer according to the following
direl::tions.
After du+frosting:
1. Hool drain hose in place.
2. Repl :rce base grille.
3. Plug
In
power cord.
4. See :lirections for “Setting the Cold Control,”
pagci: 5.
support Tabs
To repkrce:
1 Line u :I grille support tabs with metal clips
2 Push f ,mly to snap Into place
3.
Close the door
7