Filter
Top Products
CLOCK
TIMER
TIMER
10
USING YOUR RANGE
THE ELECTRONIC TIME-OF-DAY (TOD) CLOCK/TIMER
Oven timer
pad
(p. 11)
Display/clock
• When you first plug in the range, “PF” will
appear on the display. If “PF” appears again on
the display, your electricity was off for a while.
• When you are not using the oven, the display
either shows the time of day or will be blank.
Electronic display
Clock pad
(pp. 10, 13)
Increase
pad
(pp. 10, 11,
13, 19)
Decrease
pad
(pp. 10, 11,
13, 19)
• When showing the time of day, the display will
show the hour and minutes.
• When you are using the timer, the display
will show seconds for time less than 1 minute,
minutes for time less than 1 hour, and hours
and minutes for time over 1 hour. The timer
indicator light will be lit when in the timer mode.
SETTING THE CLOCK
1. Press CLOCK. The colon flashes during
clock programming.
2. Set the time.
Press the “up” (▲) or “down” (▼) pad(s) until
the correct time shows on the display.
NOTE: Press a pad briefly to change time by a
small amount. Press and hold a pad to change
time by 10 minute increments.
3. Press CLOCK again to start the clock. The colon
stops flashing when the clock is active.
PRESS YOU SEE
PRESS YOU SEE
PRESS YOU SEE