Filter
Top Products
20
Removing the Pump Assembly
The entire pump assembly can be removed from inside the dishwasher tub.
1. Remove the access and toe panels from
underneath the dishwasher door by re-
moving the two (2) screws securing it to
the dishwasher frame. (Fig. 3-15)
2. Disconnect the wiring harness connectors
from the drive motor and pump motor
terminals, the soil sensor and the thermistor.
3. Disconnect the drain hose from the drain
hose connector on the pump outlet.
4. Remove the pump motor. (See next
page.)
5. Remove the three (3) sump tabs that
secure the sump assembly to the dish-
washer tub. (Fig. 3-16, Inset)
6. From inside the tub, lift the front of the
sump up approximately ½ inch.
Push the assembly back and then lift it out.
Fig. 3-15
Fig. 3-16
SERVICING COMPONENTS IN THE SUMP ASSEMBLY
Removing the Wash Motor
1. Remove the bolt securing the wash
motor and drip shield in place on the pump
assembly. (Fig. 3-18)
2. Once the bolt and drip shield are removed,
turn the wash motor until it stops (approxi-
mately ¼ turn).
3. Pull the motor straight back from the sump
assembly. Some effort may be necessary
to dislodge the motor. The volute will re-
main attached to the motor. (See Figure
3-29)
NOTE: When reinstalling the wash motor and
volute, do not pinch the volute seal between the
volute and sump. Use a small amount of rinse
aid on the volute seal to help installation.
Fig. 3-17
NOTE: When reinstalling the sump assembly,
align the locator key with the corresponding
slot in the tub opening.
Drip Shield
Access Panel
Toe Panel
Inset
Sump Tab
Sump Tab
Sump
Tab
Inset
Bolt Holds Drip
Shield in Place