Filter
Top Products
4-10
10. Disconnect the inlet tube and the vent tube
from the internal drain pump.
12. Disconnect the wire connector from the
condenser fan motor.
13. Remove the four screws (two bottom and
two side) from the condenser fan motor
shroud. Slide the shroud assembly back
towards the compressor, and then lift and
remove the assembly from the unit.
11. Tilt the front of the cabinet up until you
can access the two side screws on the
condenser fan motor shroud, and secure
the cabinet so that it cannot tip forward or
backward.
Tubing
Internal Drain Pump
Condenser Fan Motor Left Side Shroud Screw
Continued on the next page.
Condenser Fan Motor Bottom Shroud Screws
Motor Connector
Tilt