Filter
Top Products
4-19
REMOVING THE COMPRESSOR
1. Unplug ice maker or disconnect power.
2. Open the ice maker door.
3. Remove the ice from the storage bin.
4. Disconnect the water and drain lines from
the ice maker and remove the unit from its
installation.
5. At the rear of the unit, remove the four
screws from the unit compartment cover
and remove the cover.
Unit Compartment Cover
4 Screws
6. Remove the terminal cover using a stan-
dard screwdriver. Insert the screwdriver
into the cover slot, and press down to
unsnap and remove it.
Compressor
Terminal Cover
Cover Slot
7. Remove the wires from the ground termi-
nal, the overload protector terminal, and
the relay terminal.
8. Pull the overload protector and relay from
the compressor pins.
Ground Wire
Overload
Protector
Relay
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING
WARNING
Continued on the next page.