Filter
Top Products
Number Pads
Fan and light Pads
Once you’ve touched a Command Pad to fell
ihe oven what you want if to do, you’ll touch
Number Pads to fell if...
-a time.
- a Cook Power.
-a food temperature.
The six pads at the bottom of the control
panel control the 2-Speed Exhaust Fan and
the Cooktop Light.
Touch Fan Pad for the desired fan speed.
(NOTE: if the temperature gets too hot aroirnd
the microwave oven, the exhaust fan in the
vent hood will automatically turn on the LOW
setting to protect the oven. it may stay on up
to an hour to cool the oven. When this occurs,
the Pan Pad will not turn the fan off.)
Touch Light Pad for the desired cooktop or
countertop lighting.
Audible Signals
Audible signals are available to guide you when setting and using your oven. (A programming tone wlil
sound each time you touch a pad. Two beeps will sound between cycles. A reminder tone will sound every
60 seconds after cooklng Is done to remlnd you that something has been left in the oven. Four beeps signal
the end of the Mlnute Tlmer function and a Cook or Defrost cycle.] If you don’t hear a tone, if is because of
Incorrectly entered InstructIons or because the tones have been removed. For example, a tone will not
sound if you touch a Number Pad before you touch a Command Pad.
lo remove the programming tone and
To remove ail tones:
reminder tone:
l Open the door.
l Open the door.
l Touch CANCEL twice, touch 0, then touch START.
l Touch CANCEL twice, then touch START.
l Programming and remlnder tones will be
l All audible tones (including Kitchen Timer
signal] will be canceiled.
cancelled.
To replace the tones:
l Repeat the steps above.
NOTE: Do not remove ail tones if you use the
Minute Timer.
To replace the tones:
l Repeat the steps above.
NOTE: If your electricity goes off, the tones will be replaced when the eiectricfty comes back on.
Setting the Clock
When the oven Is first plugged in, a tone sounds and the Display shows “88:88:’ If the
electric power ever goes off, the Display will again show ail 8’s when the power comes
back on.
You can cook or use the Minute Timer wlfhout setting the Clock, but the Display will be
blank after cooklng.
DO THIS...
THIS HAPPENS...
The Display will show a “0” and the
colon will start to flash. The first
Number Pad must be touched within
5 seconds or the Display will go
blank. If this happens, touch CLOCK
SET again and continue.