Whirlpool MW8650XS Microwave Oven User Manual


 
6. Touch START.
can stop the beeping by opening the
BE
,fp BEEP BEEP BEE
P door or by touching CANCEL.) “End”
WIII remain on the Display and a
reminder tone will sound every 60
seconds until the door is opened or
CANCEL is touched. The Display will
then show the time of day.
The AUTO SET and PROBE TEMP
Indicator Lights will stay on.
The Display will show “COOL” to
show the food is less than 9O’F.
As the food cooks the Display will
show the internal temperature of
the food for every 5’F increase.
When the probe senses the tem-
perature you selected, the oven
shuts off. “End” will show on the
Display and 4 beeps will sound. (You
NOTE: You can set Auto Set TEMP to follow COOK.
Auto Set TEMP can be programmed with the Temperature Probe out, but the oven will
pause between the last Cook cycle and TEMP. “PROB” will show on the Display to remind
you to plug in the Temperature Probe.
Changing the Pre-Programmed Setting
You can change the pre-programmed temperature and Cook Power in Auto Set TEMP to
the temperature and power you most often use. To change the Auto Set TEMP setting, follow
these steps:
1.
Insert at least ‘/3 of the Temperature Probe into the food
2. Place food in the oven and close the door.
3. Touch TEMP twice
4. Touch the Number Pads for the new desired temperature between 90-F and 200 F
If HIGH Cook Power is desired, skip to Step 6.
5. Touch COOK POWER.
6. Touch the Number Pad for the desired Cook Power
7. Touch START. The oven will cook to the new temperature at the Cook Power you
selected. After the cooking is complete, the oven will remember that temperature and
Cook Power for future use. NOTE: If the electric power goes off, the oven will go back
to the pre-programmed 165°F at HIGH Cook Power setting.
Additional Information
l
Temperature may be changed after START is touched by touching TEMPthe new number
and START.
l
Auto Set TEMP will follow the Cook cycle if programmed.
l
“PROB” will show on the Display after START is touched if the probe is not plugged into the
oven. This will only appear when Auto Set TEMP has been selected alone, or between the
last Cook cycle and Auto Set TEMP selection.
l
“Err” will show on the Display after START is touched if an Incorrect temperature has
been selected (under 90°F or over 200-F).
l
See “Hints for Using the Temperature Probe” on page 19.
14