Whirlpool MW8900XS Microwave Oven User Manual


 
When SLOW COOK/SIMMER ends, “End”
will show on the Display and 4 beeps
will sound. (You can stop the beeping
by opening the door or by touching
CANCEL.) “End” will remain on the Dis-
play and a reminder tone will sound
every 60 seconds until the door is
opened or CANCEL is touched. The Dis-
play will then show the time of day.
NOTE: If food is removed from oven during KEEP WARM, touch KEEP WARM then
CANCEL to cancel remainder of the time.
AUTO SENSOR operating hints
l
ALL AUTO SENSOR cooking categories have preset Cook Powers.
l
The COOK POWER Indicator Light does not come on during AUTO SENSOR Cycles.
l
No Cook or Temperature cycles can be used with AUTO SENSOR Cycles,
l
Auto Start may be used with AUTO SENSOR Cycles.
l
Quick Defrost and Keep Warm may be selected with Cook/Reheat or Cook Frozen
only. Keep Warm is automatic at the end of Slow/Cook/Simmer cycle.
l
Pause may be used with Cook/Reheat or Cook Frozen only. It will stop the oven
between the first and second part of the cycle. See “Using PAUSE:’ page 20.
l
In Cook/Reheat and Cook Frozen “AS-#” will show on the Display until the oven calcu-
lates and begins counting down the remaining cooking time, except ‘AS-I” which stops
after the first part of the cooking cycle.
l
The AUTO SENSOR Indicator Light goes off at the end of the first part of the Slow
Cook/Simmer cycle.
l
“Err” will show on the Display if the door is opened during the first part of any AUTO
SENSOR cycle. “Err” will also show on the Display if AUTO SENSOR malfunctions. Open the
door and touch CANCEL to clear the Display. Do not reset AUTO SENSOR. The food may
over or undercook. To finish cooking food, estimate the remaining cooking time. Reset
the oven using the COOK cycle and approximate Cook Power setting.
Cooking at High Cook Power
1
DO THIS...
Put food in the oven and
close the door.
2.
Touch COOK.
3. Touch Number Pads for the
cooking time you want.
THIS HAPPENS...
The COOK Indicator Light will come on
and the Display will show four 0’s.
The Display will show the numbers you
touched in the order you touched
them. The example shows 1 minute, 30
seconds.
12