Filter
Top Products
Audible Signals
Audible signals are available to guide you when setting and using your oven. (A programming tone
will sound each time you touch a pad. Two beeps will sound between cycles A reminder tone will
sound every 60 seconds after cooking is done to remind you that something has been left in the oven.
A 3 second tone signals the end of the Minute Timer function.] If you don’t hear a tone, it is because
of incorrectly entered instructions or because the tones have been removed. For example, a tone will
not sound if you touch a Number Pad before you touch a Command Pad.
To remove the programming tone and
To remove all tones, except the Minute
reminder tone:
Timer signal:
l
Open the door.
l
Open the door.
l
Touch CANCEL twice, then touch START.
l
Touch CANCEL twice, touch 0, then touch START.
l
Programming and reminder tones will be
l
All audible tones (except Minute Timer signal)
cancelled.
will be cancelled.
To replace the tones:
To replace the tones:
l
Repeat the steps above.
l
Repeat the steps above
NOTE: If your electricity goes off, the tones will be replaced when the electricity comes back on.
Setting the Clock
When the oven is first plugged in, a tone sounds and the Display shows “88:88:’ If the
electric power ever goes off, the Display will again show all 8’s when the power comes
back on.
You can cook or use the Minute Timer without setting the Clock
blank after cooking
DO THIS...
THIS HAPPENS...
1. Touch CLOCK SET.
Elma
2. Touch Number Pads for the
correct time of day.
3.
Touch START.
but the Display will be
The Display will show a “0” and
the colon will start to flash. The
first Number Pad must be touched
within 5 seconds or the Display will
go blank. Touch CLOCK SET again
and continue.
The Display will show what numbers
you touched in the order you
touched them. This example shows
3:25.
The colon will stop flashing. The Clock
is set.
If you have touched in an incorrect
time, such as12:65, “Err” will show on
the Display. Touch CLOCK SET and
start over.
NOTE: To etthe clock, touch CLOCK SET. The current time will show on the Display
and the colon will flash. Continue to set the clock as shown above.
6