Filter
Top Products
Removing the base grille
To remove the grille:
1. Open both doors.
2. Pull base grille forward to release the
support tabs from the metal clips.
3. Do not remove Tech Sheet fastened
behind the grille.
To replace the grille:
1. Line up grille support tabs with metal
clips.
2. Push firmly to snap into place.
3. Close the doors.
See cleaning instructions for defrost pan and
condenser coils on page 22.
Condenser
coils 1
Using the THIRSTCRUSHER* dispensing system
(on some models)
The ice dispenser
Ice dispenses from the ice maker storage
bin in the freezer. When the dispenser bar is
pressed, a trapdoor opens in a chute
between the dispenser and the ice bin. Ice
moves from the bin and falls through the
chute. When the dispenser bar is released,
a buzzing sound may be heard for a few
seconds as the trapdoor closes. The dis-
penser system will not operate when the
freezer door is open.
For crushed ice, cubes are crushed before
being dispensed. This may cause a slight
delay when dispensing crushed ice. Noise
from the ice crusher is normal, and pieces of
ice may vary in size.
When changing from CRUSHED to CUBE,
a few ounces of crushed ice will be dis-
pensed along with the first cubes.
To dispense ice:
1. For cubed ice, move Ice Selector Switch
to CUBE position.
For crushed ice (on some models), move
Ice Selector Switch to CRUSHED position.
Personal Injury Hazard
Tumbling ice and pressure on a fragile
glass can break it. Use a sturdy glass
when dispensing ice or water.
Failure to do so could result in personal
iniurv or breakage.
16