Filter
Top Products
Removing the Doors
Please read these helpful hints before you
start
l Before you start, either unplug the refrig-
erator or disconnect the electricity leading
to it at the main power supply and remove
any food from door shelves.
l When removing hinges, keep doors closed
until ready to lift free from cabinet.
l To remove doors, start at the top hinge
and work down.
Cabinet
l To replace doors, start at the bottom hinge
and work up.
l Line up doors so they are centered
between the sides of the cabinet and are
parallel with each other.
l If refrigerator light does not go out when
door is closed, the door may be too low.
Use a thicker spacer if necessary.
l Door seal may be adjusted by removing
the top hinge and adding or removing
shims to the bottom hinge.
l Set the door gap at 17.5 mm (‘l/16 inch).
The diameter of a dime is about right.
See figure.
l The refrigerator must be level and sitting
on a solid floor.
8
mm
(%6”)
Countersink
hex-head handle
hinge screw screw
Oval sealing
screw
(use on bot-
toms of doors)
Handle
screw
Oval sealing
screw (use
on tops of
doors)