Solid Element Surface Units
Burn or Electrical Shock Hazard
Solid element surface units do not glow red when hot. Make sure aU
controls are OFF and the range is COOL before cleaning. Failure to do
so can msuit in burns or electrical shock.
1.
Turn oft all surface units.
3. IMPORTANT: After cleaning, apply
a thin coat of salt-free oil to the
CCCL surface units, then heat 3-5
minutes. It may still smoke slightly
when heated. If surface units have
dark spots caused by grease and
food,the oil treatment will improve
their appearance but not elimi-
nate the spots. NOTE: Optfonai
ElecttoP dressing can be
applied to the surface units to
improve their appearance.
16
2. For best results, wipe off surface
units with a damp soft cloth and
soapy water afler each use.
Burned-on food may be removed
with a soapy scouring pad. The
red spot in the center of the sur-
face unit will gradually wash off.
This is normal and will not affect
the operation of the surface unit.
4. The stainless steel trim rings will
gradually yellow from the heat of
the surface units and pans. This is
normal. The yellowing can be
removed by using stainless steel
cleaner or Cook Top Polishing
Creme on the trim rings.
To obtain order information for
Cook Top Polishing Creme (Part
No. 814009) or Electrol@ dressing
(Part No. 814030), write to:
Whirlpool Corporation
Attention: Customer Service Dept.
1900 Whirlpool Drive
LaPorte, IN 46305