Filter
Top Products
3. Pull the surface unit straight away
from the receptacle.
Replacing
4. Lift out the reflector bowl and trim
ring. See “Cleaning Chart” on
page 22 for cleaning instructions.
2. Line up openings in the reflector
bowl and notches in the trim ring
with the surface unit receptacle
and the element hold down clip.
3. Hold the surface unit as level as
possible with the terminal just
started into the receptacle. Push
the surface unit terminal into the
receptacle.
4. When terminal is pushed into the
receptacle as far as it will go, push
down the edge of the surface unit
opposite the receptacle. The ele-
ment hold down clip will keep the
surface unit from moving around.
17