Filter
Top Products
To remove surface
unit. Ilh and pull
straight out.
Hold surface unlt level
when replaclng.
Removing surface units and reflector bowls:
1. First be sure the Surface Unit Controls are all “OFF” and that the
surface units are cool.
2. Lift each surface unit about an inch (2.5 cm) at the edge away from the
plug-in (receptacle). Pull the unit straight away from the plug-in. Do
not
wash surface
units; they will burn themselves clean during normal
USe.
3. Lift out the reflector bowls
Replacina reflector bowls and surface units:
;:
Be sure the surface unit controls are on “OFF”
Put the reflector bowls back into their places Make sure you can see
the plug-ins (receptacles) for the surface units through the square
hole in the side of each bowl.
3.
4.
Hold the surface unit level with the prongs (terminals) pointing at
the plug-in.
With the prongs started in the plug-in, start pushing in on the surface
unit. At the same time. lrft a little on the side of the surface unit that’s
by the plug-in.
Make sure the surface-unit prongs are pushed into the plug-in as far as
they will go. The surface unit should fit into the reflector bowl and be
level.
.5
-.
leaning under the cooktop:
Prop up the top with
support rod.
To clean the area under the cooktop, lift the front of the cooktop at
nter. Raise the swing-up rod to hold it. (Be sure the tip of the rod is
notch in the cooktop.) Use warm soapy water and a sponge or cloth.
ring powders or any other abrasive cleaner may harm porcelain-
enamel finishes and can scratch chrome.
Be careful not to raise the cooktop so high that it touches the
control console. And don’t drop it. Dropping the cooktop can chip or crack
a hard porcelain finish. or damage side panels and surface units.
7