Filter
Top Products
4.
Lift
out the reflector bowl. See “Cleaning
chart” on page 31 for cleaning instruc-
tions.
Replacing
1. Make sure
all surface units are off before
replacing surface units and reflector
bowls.
2. Line up
openings in the reflector bowl
with the surface unit receptacle.
3.
Hold
the surface unit as level as possible
with the terminal just
started
into the
receptacle.
Push
the surface unit terminal
into the receptacle.
4. When terminal is pushed into the receptacle
as far as it will go,
push down
the edge of
the surface unit opposite the receptacle.
Make
sure surface unit is properly posi-
tioned
and
level.
NOTE:
Reflector bowls reflect heat back to the
utensils on the surface units. They also help
catch spills. When they are kept clean, they
reflect heat better and look new longer.
If a reflector bowl gets discolored, some of
your utensils may not be flat enough, or some
may be too large for the surface unit. In either
case, some of the heat that’s meant to go into
or around a utensil goes down and heats the
reflector bowl. This extra heat can discolor it.
28