Filter
Top Products
PART
Oven racks
Oven door
glass
WHAT TO USE
HOW TO CLEAN
Self-Cleaning cycle.
l
Leave in oven during Self-Cleaning
Warm soapy water or
cycle.
soapy steel wool pads.
OR
l
Wash, rinse and dry. Use soapy steel
wool pads for heavily-soiled
areas.
NOTE: The oven racks will dlsoolor and be harder to slide when
lefl In the oven during the Self-Cleanlng cycle. If you want them to
stay rhlny, remove from the oven and clean by hand. If racks are
letl In the oven durlng the SelfCleanIng cycle, apply a small
amount of vegetable oil to the slder of the racks to make them
easler to sllde.
Spray glass cleaner or
l
Make sure oven Is cool.
warm soapy water and a
plastic scrubbing pad.
l
Follow directions provided with
the cleaner.
l
Wash, rinse and dry well.
I
Self-Cleaning
Oven
For areas outside the
Self-Cleaning area use
warm soapy water or
soapy steel wool pads.
l
Follow directions starting on
page20. “Using the Self-Cleaning
Cycle!’
l
Do not use commercial oven
cleaners.
l
Do not use toll to line the bottom
of vour Self-Cleanlna Oven.
The Oven Light
The oven light will come on when you open the oven door. To turn the light on
when the oven door is closed, push the Oven Light Switch on the oven control
panel. Push it again to turn off the light.
Electrical Shock and Personal Injury Hazard
l
Make sure oven and light bulb are cool and power to the oven has
been turned OFF before replacing the Ilght bulb. Failure to do so could
result in electrlcal shock or burns.
l
The bulb cover must be in place when using the oven. The cover
protects the bulb from breaklng, and from high oven temperatures.
Broken glass could cause injury.
.
Unplug appliance or disconnect
at the main power supply.
2. Remove the bulb cover in the
back of the oven by pulling out
and pushing the wire holder to
the side.
continued on next page
25