Filter
Top Products
Product Damage Hazard
Do not remove the cooktop.
Doing so-could result in product damage
Surface burners and cooktop
The cooktop and burner box areas are
specially designed to make cleaning easier.
Because the four burners are sealed,
cleanups are easy and convenient.
To clean the cooktop, wipe
with a damp
sponge and
dry.
Cleaning the contoured well
areas
The contoured well is a recessed area
located around each burner.
If spills occur in contoured well section:
1. Blot up
spill with a paper towel.
2.
Wipe
with a clean, damp sponge.
3.
Dry.
NOTE:
When cleaning the cooktop area or
around the burner base, use care to prevent
damage to the ignitor. lf a cleaning utensil
should catch it, the ignitor could be damaged
or broken. If the igniter is damaged or
broken, the surface burner will not light.
When cleaning the cooktop, leave the burner
cap in place to protect the ignitor from
possible damage.
Cleaning the surface burners
l
The burner caps
should be routinely
removed and cleaned. Always clean
burner caps after a spillover. Keeping the
burner caps clean prevents improper
ignition and an uneven flame.
l
For proper flow
of gas and ignition of the
burner, DO NOT ALLOW SPILLS, FOOD,
CLEANING AGENTS OR ANY OTHER
MATERIAL TO ENTER THE GAS TUBE
OPENING.
l
Gas must flow freely
through the small
hole in the brass orifice for the burner to
light properly. This area must be free of
any soil and be kept protected from
boilovers or spillovers. ALWAYS keep the
burner caps in place whenever a surface
burner is in use.
Contoured
HBurner cap
\w/ ’ Burner pan
Gas tube
opening
Igniter’
24