Whirlpool SF367PEY Range User Manual


 
PROBLEM
Self-Cleaning
cycle will not
Dperate
POSSIBLE CAUSE SOLUTION
The Oven Selector and Oven Set both the Oven Selector and Oven
Temperature Control are not
Temperature Control to CLEAN.
set to CLEAN.
The range clock does not
Reset clock to show the correct time
show the correct time of day.
of day. (See page 11.)
The Lock Lever is not in the
Move Lock Lever all the way to
CLEAN positior+all the way
the right.
to the right.
The Start Time Dial does not
Reset the Start Time Knob to show
show the correct time of day
the correct time of day. Pull knob out
or the knob is not all the way
all the way.
Out.
The Stop Time Dial is not set
See Step 3 in “Setting the controls”
ahead to the time you want
on page 21 for proper setting
the self-cleaning cycle to stop.
instructions.
Cooking results
The range is not level. Level range. (See Installation
m not what you
Instructions.)
sxpected
The oven temperature seems
Adjust the oven temperature control.
too low or too high. (See “Adjusting the oven temperature
control” on page 13.)
The oven was not preheated
Preheat oven if called for in recipe.
as the recipe calls for.
The recipe has never been
Use only tested recipes from a
tested or is not from a reliable
reliable source.
source.
The pans are not the type or
size recommended in the
recipe.
Refer to
a
reliable cookbook for
recommended pan type and size.
There is not proper air
circulation around pan when
baking.
Allow 1 Yz to 2 inches (4-5 cm) on all
sides of the pans for air circulation.
There must be a minimum space of
1 inch (2.5 cm).
Flame size does not fit the
cooking utensil being used.
When broiling, you have not
completely closed the oven
door.
Adjust flame size to fit cooking
utensil.
Completely close oven door.
30