Whirlpool SS3004SR Range User Manual


 
The Oven Vent
Hot air and moisture escape from
the oven through a vent located to
the rear of the cooktop. Do not
block vent. Poor baking will result.
Lighting Standing Pilots
To light
Cookto~
Pilots:
.
1.
Remove the surface burner grates
from the cooktop. Lift the cooktop
and rest on support rod.
2. Make sure all controls are OFF.
To light Oven Burner Pilot:
1.
Make sure the oven control is OFF.
2. Remove the broiler drawer. Slide
drawer out to stops, lift both sides,
then slide the rest of the way out.
3. To light, hold a lit match over the
pilot light located between the
front and back burners. The pilot
flame should be % to J/e in
(.635-,953 cm) high.
4. If the pilot flame needs adjust-
ment, turn the pilot adjustment
screw on the manifold pipe.
5. Lower the cooktop and replace
the surface burner grates before
using the surface burners.
I
I
3. Hold a lit match over the oven
burner pilot located at the rear of
the burner.
4. After the oven burner pilot is burn-
ing steady, check burner lighting
by turning the Oven Control to a
temperature obove140”F (60°C).
The burner will take 50-60 seconds
to light.
5. Replace the broiler drawer.
9