Filter
Top Products
PROBLEM
Burner flames
are uneven
POSSIBLE CAUSE
Burner ports are clogged.
SOLUTION
Clean with a straight pin (see pages
31 and 34). If this fails, call an
authorized Whirlpoole service techni-
cian for service.
Burner flames
Air/gas mixture is incorrect.
Contact an authorized Whirlpool
lift off ports, are
service technician to check air/gas
yellow, or are
m’tiure.
noisy when
turned off
Burner makes
fgp;i;i noise
Burner is wet from washing.
Let dry.
Control knob(s)
You are not pushing in before
Push control knob(s) in before turning
will not turn
turning.
to a setting.
Self-Cleaning
The range clock does not
Reset clock to show the correct time
cycle will not
show the correct time of day.
of day. (See page 13.)
operate
A delayed start time has been Wait for the start time to be reached.
set.
Cooking results
The range is not level.
are not what you
Level range. (See Installation Instruc-
expected
tions.)
The oven temperature seems
too low or too high.
Adjust the oven temperature control.
(See “Adjusting the oven temperature
control” on page 16.)
The oven was not preheated
Preheat oven if called for in recipe.
as the recipe calls for.
The recipe has never been
Use only tested recipes from a
tested or is not from a reliable
reliable source.
source.
The pans are not the type or
size recommended in the
recipe.
There is not proper air
circulation around pan when
baking.
Refer to a reliable cookbook for
recommended pan type and size.
Allow 1% to 2 inches (4-5 cm) on all
sides of the pans for air circulation.
There must be a minimum space of
1 inch (2.5 cm).
Flame size does not fit the
cooking utensil being used.
Adjust flame size to fit cooking
utensil.
When broiling, you have not
completely closed the oven
door.
Completely close oven door.
continued on next
paw
37