Filter
Top Products
28
3. Be sure both tabs are in their slots, that
the burner sits level and straight, and that
the flash tube forms a straight line from
the ignitor to the burner.
NOTE: Occasionally check the burner
flames for proper size and shape as shown.
A good flame is blue in color. If flames lift off
ports, are yellow, or are noisy when turned
off, you may need to clean the burners (see
the previous page), or call a qualified
technician for adjustment.
Removing the oven bottom
The oven bottom can be removed to clean
large spills, but oven bottom must be
replaced before using the Self-Cleaning
cycle.
NOTE: Make sure all parts are cool before
removing oven bottom.
To remove:
1. Slide the tab at the center front of the
oven bottom to the left.
2. Lift the oven bottom up and out.
To replace:
1. Slip the oven bottom into the oven so the
tabs in the rear of the oven bottom fit into
the slots in the oven back.
2. Lower the front of the oven bottom into
place and slide the front tab to the right
to lock the oven bottom into place.
NOTE: See the “Cleaning chart” later in this
section for information on cleaning the oven
bottom.
continued on next page
CARING FOR YOUR RANGE
1
2
"
Ports
Typical surface burner flame
at highest setting
LockUnlock